Grooming and trimming your fluffy Poodle dog with those fancy haircuts we often see can take a lot of practice. Fortunately we have outlined a step-by-step system that will guide you through the process.

The first step is obtaining the proper equipment. You will only need a few items: a slicker brush, a steal comb, and ear powder (preferably medicated).

1. First clean the ears by clean the ears by dusting the inside with medicated ear powder and pull out any dead hair with your fingers. Cut the nails with a scissors-type nail clipper, removing only the tips of the nails so as not to cut the quick. And clip the feet with a #15 blade using an the ankle bone as your guideline. Using the corner of the blade, click up one side and then up the opposite side of each toe. Scoop the hair out from between the pads on the backs of the feet.

2. Clip the face with a #15 blade. Clip from the bottom of the ear up to the corner of the mouth. Using the same blade, clip under the eye and down the sides of the muzzle, and from the stop (between the eyes) to the tip of the nose. Stretch the lips back with your thumb to remove the hair around this area. If a mustache is preferred, leave the hair on the muzzle from just behind the corners of the mouth to the nose, clipping only from the stop down the muzzle to the nose, using the #15 blade.

3. Clip the tail with the #15 blade going against the grain on the top side and with the grain on the underside. The amount of hair clipped from the tail depends on Nail Clipper (scissors type).

4. Clip the stomach area (from the groin to the navel) with the #10 blade. To set the pattern on the body use either a #10 or a #7 blade. Clip from the base of the skull to the base of the tailed. With the same blade clip down the entire rear leg to 1/4 inch above the hock joint. Also clip on the inside of the leg down to the same point. Clip down the sides of the neck, using the same blade, to the elbow, and then to a line on the front leg even with the line at the hock joint on the rear leg. Clip on the inside of the leg down to the same line. Clip the rest of the body with the same blade, back, and chest going with the grain.

5. Brush the remaining hair on the legs with a slicker brush. Comb through the hair to make sure it is mat free. Bathe and dry. Use the fluff-dry method on the topknot, ears, and tail and leg pom-poms (bracelets).

6. Comb through the coat thoroughly after drying. Scissor around the cuffs on the legs to even them off. Tease the leg pom-poms (bracelets) and scissor them so that they appear round and fluffy. Scissor the front legs the same as the rear legs. Comb the head and ears. Tease the head with your comb.
Scissor the tail pom-pom so that it appears round and fluffy.

Giving a dog a bath can be as simple as rinsing him down in a child’s swimming pool in the backyard during the summer, or as complex as a full-blown spa ritual, complete with bathing a harness and a bevy of fancy coat products designed to whiten, darken, brighten, do-tangle, shine, and leave your dog with a designer aroma to rival a fancy French perfume. However, there are many ways to make bathing easier, and many ways in which bathing makes subsequent grooming sessions easier, too.

Bathing Inventory Tools

Once your dog is completely brushed, combed, and tangle-free, he is ready for a bath. Now you must get ready, too, and that means preparing all the necessary equipment and supplies so that you can reach what you need when you need it. lf you put that dog in the bathtub under running water and then have to go in search of shampoo or a scrub brush, we all know what will happen: a jump, a shake, and you will be a left with a soaked bathroom and a wet dog bounding around the house.

To wash your dog, you will need some basic supplies: shampoo, conditioner, sponge, scrub brush, bath mat, a hand-held sprayer (or large cup for rinsing), a plastic apron for you to avoid getting wet, a nylon collar and leash (if your dog has a tendency to bolt away), and finally, a heavy towel

Choosing A Shampoo

With so many shampoos on the market, it’s not easy to decide which to use. Yet, for most breeds, a basic, all-purpose shampoo is fine. If you want your shampoo to do more than clean, you might also consider a specialty shampoo.

* Accentuate your dog’s coat color by choosing a shampoo made for white, black or red coats.
* Shampoos designed to deliver extra conditioning to long or curly coats can make post-bath grooming even easier.
* For wire-coated dogs, look for a shampoo designed to preserve the crisp texture of your dog’s coat.
* Many dogs have sensitive skin or eyes. A hypoallergenic shampoo can minimize sensitivity reactions to bathing.
* lf your dog already has a rash, allergies, itching, or other sensitive skin conditions, look for a medicated shampoo designed to treat your dog’s problem (your vet should be able to recommend a good medicated shampoo for your dog).
* Is it flea season? Then consider a shampoo containing a gentle anti-flea ingredient such as pyrethrin or limonene, or any of several natural botanicals designed to repel fleas, such as neem oil.
* If your dog has sensitive eyes then consider a “tear-less” shampoo.

The Miniature Pinscher has a very short and glossy shedding coat that requires very low maintenance. Aside from regular brushing, the Miniature Pinscher should be bathed every three or four months. The ears should be cleaned once a week and the nails should be checked once every month to see if they need clipping.

Equipment needed to groom the Miniature Pinscher:

Hound Glove
Ear Powder (medicated)
Nail Clipper (scissors type)
Scissors
Lanolin Coat Conditioner
Chamois cloth

1. Brush the coat thoroughly with a hound glove.
2. Clean the ears by dusting the inside with medicated ear powder.
3. Cut the nails with a scissors-type nail clipper, removing only the tips of the nails to avoid cutting the quick.
4. Bathe and cage or towel dry.
5. Scissor the whiskers on the muzzle as well as any long hair over the eyes and on the face.
6. For a glossy coat, apply a lanolin coat conditioner by first putting a small amount on your hands and then rubbing it onto the coat. Use a chamois cloth to rub the coat to give it a shiny appearance.